Dremel 4000-DR-RT Use and Care Manual download pdf (Page 18)

Mandrel N° 402 has a small screw at its tip,

and is used with emery cutting wheels and

sanding discs. Higher speeds, usually

maximum, are best for most work, including

cutting steel. Which is shown here.

Mandrel No. 401 is used with the felt

polishing tip and wheels. Thread the tip on to

the screw carefully. The felt tip must thread

down straight on the screw Mandrel, and be

turned all the way to the collar.

To replace a band on the Drum Sander,

loosen the screw without removing it to

contract the drum then slide the old band off.

Slide the new sanding band on and then

expand the drum by tightening the screw once

again.

Before each use, check to

make certain that all

components are assembled to accessory

shank and that the drum is sufficiently

expanded to secure the band during use. If

sanding band is loose on the drum during

operation it may “fly” off and strike you or

bystanders.

WARNING

DM 2610016589 05-12_DM 2610016589 05-12.qxp 6/26/12 2:12 PM Page 18

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 67 68

No comments

Dremel 4000-DR-RT Use and Care Manual Page 18