Dremel 876 Specifications download pdf (Page 35)

Product Time Cone Temp. & Vented Non-vented Notes

Ramping Rate Kiln Kiln

One Strokes

Opaque

Underglazes

Astro Gems

Glazes

6-8 hrs. for

shelf cone 04

8-10 hrs. for

shelf cone 6 or

higher

51/2-7 hrs.

04 to 6

Higher than 6

testing for color

hold should be

done.

06 – 6

1940 with 350

Ramping Speed;

Mid-range cone 6 -

2194 to 2232

1830 with 350

Ramping speed

Close and Fire

Top peephole left

open throughout

firing.

Top peephole left

open throughout

firing.

• Pieces should not touch when loading the kiln.

• Astro Gems: remove large crystals from bottom of ware and lids.

• Do not stilt greenware unless have too. Never stilt when high firing.

• If opaque underglazes and one strokes are not as dark as the

chip chart, they may be underfired.

• Pieces can not touch when loading kiln.

• Pieces should be finished on bottom unless doing stoneware

or porcelain.

• Should stilt pieces before firing unless firing to cone 6 or higher.

• If piece is underfired, glaze may appear milky or cloudy.

Can refire.

• If high fired glazes should be applied to greenware or pieces

fired to 04 then fire to bisque.

Lusters

31/2-4 hrs.

022

018

015

1112

1323

1479

350 Ramping Speed

Close and Fire

Top peephole left

open and lid

propped throughout

firing.

• Read product labels as to firing instructions and temperature.

• Too hot a firing can cause defects.

• Too low of a temperature can result in color wiping off after

firing.

• Stilt all pieces.

• Products need extra venting room when loading kiln.

FIRING

Greenware/

Earthenware

4-6 hrs.

1940

350 Ramping Speed

Close and Fire

Top peephole open

for first hour of

firing.

• Should not load ware when wet and moist.

• Should never touch another piece during firing.

• Remove all excess dust prior to firing.

• Do not stilt unless necessary.

Quick Reference Guide

Stoneware

Porcelain

8-10 hrs.

6-10

2232 – shelf cone 6

350 Ramping Speed

2232

350 Ramping Speed

Close and Fire

Top peephole open

for first hour of

firing.

Close and Fire

Top peephole open

for first hour of

firing.

• Should not load ware when wet and moist.

• Should never touch another piece during firing.

• Remove all excess dust prior to firing.

• DO NOT STILT.

• Must use separator on box lids and pieces that will touch.

Use porcelain sand or alumina hydra as separator.

• Better to slow the firing down than to fire fast.

• Should not load ware when wet and moist.

• Should never touch another piece during firing.

• Remove all excess dust prior to firing.

• DO NOT STILT.

• Must use separator on box lids and pieces that will touch.

Use porcelain sand or alumina hydra as separator.

• Better to slow the firing down than to fire fast.

Close and Fire

1 2 ... 30 31 32 33 34 35 36 37 38 39 40 41

Comments to this Manuals

No comments

Dremel 876 Specifications Page 35

Comments to this Manuals

Related products and manuals for Battery chargers Dremel 876